You asked: How do you change a stator on a motorcycle?

How hard is it to change a stator on a motorcycle?

Replacing the stator is not too complicated and requires a socket set and some heat resistant gasket repair silicone only. … On 2006-07 Honda Fireblades the stator is located on the left hand side behind the crash protector.

How long does it take to change a stator on a motorcycle?

You should be able to get in and out under 3 hours.

How do I know if my stator is bad?

The most obvious symptoms of a bad motorcycle stator include no spark, weak spark, or intermittent spark (also known as misfiring). Hard starts and a poorly running engine can also be clues that your stator needs to be rebuilt or replaced.

How long does it take to change a stator?

A good tech can change a stator in 3 hours and a belt in 6 or 7 hours. Your belt should go over 100,000 if it has been properly maintained.

How much does it cost to have a stator replaced?

Stator & Rotor

A new stator and rotor set typically costs between $250 and $1,500. They are stationary and rotating parts of any system that generates electricity. When they stop working seamlessly, they need repair or replacement.

THIS IS IMPORTANT:  Frequent question: Why is it important to stand up for your beliefs?

How much does it cost to replace a stator on a motorcycle?

Stator & Rotor A new stator and rotor set typically costs between $250 and $1,500. They are stationary and rotating parts of any system that generates electricity. When they stop working seamlessly, they need repair or replacement.

How much does a stator cost for a motorcycle?

Compare with similar items

This item Accel 152115 50 Amp 3-Phase Motorcycle Stator for Harley-Davidson Cycle Electric Stator CE-8012
Customer Rating 4.4 out of 5 stars (21) 4.1 out of 5 stars (22)
Price $25368 $17695
Sold By Midwest Traction Longhorn Moto
Item Weight 3.15 lbs 4.00 lbs

What causes a stator to fail?

When a stator fails, it is largely due to the degradation or aging of its insulation through external occurrences and materials being introduced into its system.